Menu
Your Cart

ARBOR FOR SLOTTING CUTTER C/W BEARING. NUT & 2 X WASHERS 1/4' SHANK

ARBOR FOR SLOTTING CUTTER C/W BEARING. NUT & 2 X WASHERS 1/4' SHANK
ARBOR FOR SLOTTING CUTTER C/W BEARING. NUT & 2 X WASHERS 1/4' SHANK
  • Stock: In Stock
  • Brand: PRO-TECH
  • Model: KP4301
  • Weight: 0.04kg
  • Dimensions: 36.00mm x 36.00mm x 36.00mm
  • SKU: KP4301
  • UPC: 6009600401860
R 192.86
Ex Tax: R 167.70
Pro-Tech. South African favourite for over 30 Years Biscuit Slot Cutter
Replacement shaft
 

Spare arbot Pro-TechArbor for Slotting Cutters

We offer a spare / loose arbor for our range of slot cutters. It comes with a ¼" shank and will accept cutters with a 5/16 " arbor hole.

PRO-TECH router bits are manufactured in Taiwan.

Router Bit Maintenance

Fortunately, this is pretty easy. The best way to prolong the life of a router bit is to keep it clean. And what you need to do varies with the type of bit.

Note: Sharpening is extremely important too.

 Bits with Bearings:

To clean bits with bearings, first, remove the bearing. Then clean the bit as you did with non-bearing bits.

It's important to remove the bearings because even though router bearings are 'sealed,' resin remover can sneak in and dissolve the bearing grease. If this were to happen, you would be faced with the problem of trying to lubricate a sealed bearing.

Despite the claims of bearing grease sellers, we've never had much luck with this. Once that grease is gone, just go buy a new bearing.

 Bit Shanks:

Periodically inspect the shanks of your router bits for rust or burrs. Either of these can be removed quickly with ScotchBrite®. Left on, they can interfere with your ability to properly tighten the bit in the collet.

Replacement shaft for slot cutters

Part number Shank size
KP4301 ¼" | 6,35 mm

 

Write a review

Note: HTML is not translated!
Bad Good
This is the sticky Notification module. You can use it for any sticky messages such as cookie notices or special promotions, etc.