Chuck & Gear Housing Assembl Kit (1-7) For Tcrh0800

Features

• Chuck and gear housing assembly kit Replaces the key front-end components in one service-ready kit.
• Parts-diagram referenced fitment Covers reference parts (1–7) for accurate servicing and rebuild work.
• Designed for TCRH0800 Intended for use on the Tork Craft TCRH0800 where this assembly is specified.

Benefits

• Restores secure tool holding: Helps bring back proper bit retention and reduces unwanted play at the chuck.
• Improves reliability under load: Correct housing alignment supports smoother power transfer and more consistent performance.
• Reduces vibration-related wear: Replacing worn or damaged front-end parts can prevent knock-on damage to gears and bearings.

Extra Information

• This service kit covers the chuck and gear housing assembly components referenced as parts (1–7) for the TCRH0800.
• Recommended if the housing is cracked, mounting points are stripped, the chuck area has excessive play, or the gearbox section shows damage or misalignment.
• During rebuild, inspect related wear items (bearings, seals, grease condition and fasteners) to prevent repeat failures.

Specifications

Safety

• Disconnect the tool from the power supply before any servicing, stripping, or reassembly work.
• Wear eye, ear and dust protection when servicing or testing rotary hammers.
• Use correct tools and torque practices—over-tightening can crack housings or strip threads.
• After reassembly, perform a cautious no-load test first, then a light-duty test to confirm smooth running before returning to full work.