Menu
Your Cart

DIAMOND CORE BIT 12MM FOR TILES

DIAMOND CORE BIT 12MM FOR TILES
DIAMOND CORE BIT 12MM FOR TILES
  • Stock: In Stock
  • Brand: TORK CRAFT
  • Model: TC180812
  • Weight: 0.03kg
  • Dimensions: 113.00mm x 63.00mm x 20.00mm
  • SKU: TC180812
  • UPC: 6009515802349
R 98.67
Ex Tax: R 85.80
Ø10mm Diamond core bit

Application:

The diamond core bit is used to drill holes in:

  • Ceramic tiles
  • Marble
  • Grade 5 porcelain (hardest)
  • Granite
  • Glass
  • Slate

The diamond core cuts faster, smoother and lasts longer than any other core drills.

How to use the diamond core bit:

The diamond core drill bit must be used with water at all times when drilling. The water serves as a coolant to prevent the diamonds from overheating. The maximum allowable temperature for a diamond core bit is 500°C.

There is no pilot drill with the diamond core bit. A low rpm rotary drill with a planetary gearbox is required to be used with a diamond core bit. It is possible to use a cordless drill, but in the lowest gear setting. No hammer action is used.

  1. Tightly fasten the diamond core bit in the drill's chuck.
  2. Keep the bit steady at a 45° angle with the starting point on the edge of the assigned area to be drilled whilst the bit is rotating.
  3. A notch will be made (this is normal). Gradually move the drill from 45° to 90° and continue drilling until finished.
  4. Allow the diamond core bit to cool down completely before proceeding to drill another hole.

Water can be applied by:

  • spraying water on the surface,
  • using a wet sponge,
  • attaching a water feed device. This is necessary when drilling into a wall tile.

Please have a look at the video in the tabs above showing how to use the diamond core bit.

An indication of the correct spindle speed:

DIAMOND CORE BIT DIAMETER SPINDLE SPEED
ø5.0mm 800 rpm
ø6.0mm 600 rpm
ø7.0mm 500 rpm
ø8.0mm 500 rpm
Ø10.0mm 400 rpm
More than Ø12.0mm (>10.0mm) less than 400 rpm

 

IMPORTANT:
The tool life will mostly depend on the proper usage and the hardness of the items drilled into. It is normal for a diamond core bit to last up to 10 or more drilled holes in hard tiles. Please remember to always use water when drilling with diamond core bits.

 

consider safety for your health and the people around you

General safety suggestions:

It is advisable to always have the following items nearby and in a good condition

  • Eye protection – clean and scratch free
  • Hearing protection – quality earmuffs
  • Dust masks – discard old and dirty masks
  • Gloves – for easy handling of material and hand protection
Wear Gloves Eye Protection Hearing Protection Dust Mask
Wear Gloves
Eye Protection
Hearing Protection
Dust Mask
Diamond core bit
How to use the diamond core bit

 

Download the Specification sheet:
View the Specification sheet:

Write a review

Note: HTML is not translated!
Bad Good
This is the sticky Notification module. You can use it for any sticky messages such as cookie notices or special promotions, etc.