Repl. Fuse Only 250v For Magbase Drills

Features

• 250V rated replacement fuse Designed for mag base drill electrical protection where a 250V fuse is required.
• Fuse only A simple, service-ready replacement component to minimise downtime.
• Overcurrent protection role Helps safeguard electrical components from overload conditions.

Benefits

• Helps restore operation safely: Replacing a blown fuse can bring the tool back to life with correct protection in place.
• Protects expensive components: A correctly specified fuse helps reduce the risk of damage to control and motor circuits.
• Fast, practical repair item: Small part, big impact—ideal to keep as a spare for workshop readiness.

Extra Information

• Suitable for mag base drills where a 250V fuse is specified—always match the correct fuse type and rating for your model.
• If the replacement fuse blows again, stop and investigate the cause (overload, damaged wiring, moisture ingress, faulty switch/control board or motor issues).
• Check the fuse holder for heat damage or looseness—poor contact can cause overheating and repeated failures.

Specifications

Safety

• Disconnect the tool from the power supply before replacing a fuse or opening electrical covers.
• Never bypass a fuse or fit an incorrect rating—this can cause severe damage, fire risk, and injury.
• Replace only with the correct fuse type specified for your model (size/type and rating must match).
• After replacement, test the drill cautiously at no load first and monitor for abnormal behaviour.