Polisher Service Kit Brush Holder & Cover Comp.(41-43) For Pol04

Features

• Genuine Tork Craft brush holder and cover component kit for the POL04 rotary polisher.
• Covers components referenced as items 41–43 on the POL04 parts diagram.
• Correctly positions carbon brushes on the motor commutator.
• Secure covers keep brushes in place while still allowing easy access for servicing.
• Heat-resistant materials suitable for workshop duty cycles.
• Designed to work with genuine POL04-SK11 carbon brush pairs.

Benefits

• Helps restore stable electrical contact and smoother running on the POL04.
• Reduces excessive sparking and brush chatter caused by worn holders.
• Makes future brush inspections and replacements quick and straightforward.
• Protects the commutator and windings from poor alignment and loose brushes.
• Extends the overall service life of the polisher at relatively low cost.

Extra Information

Typical signs that brush holders and covers may need attention include brushes that stick in their slots, uneven brush wear, signs of melting or discolouration around the holders, loose or missing covers, or ongoing sparking problems even after fitting new brushes. In these cases, replacing the holders and covers with the POL04-SK12 kit often solves issues that simple brush changes cannot fix on their own.

The components in this kit are designed specifically for the Tork Craft POL04 rotary polisher, so the brush slots, spring locations and cover threads all line up with the original motor casting. Pairing genuine holders and covers with genuine brushes helps keep the electrical side of the motor running smoothly in busy panel shops and detailing bays.

Pro Tip

Pro Tip: When fitting the POL04-SK12 kit, take a moment to clean out carbon dust from the brush chambers and surrounding area. Make sure the new brushes slide freely in the holders and that the springs seat correctly before refitting the covers. After reassembly, run the POL04 at low speed with no load to bed in the brushes and confirm a clean motor note before returning the tool to full-duty work.

Specifications

Safety

• Always unplug the polisher from the mains before opening brush covers or working on the motor.
• Allow the tool to cool down fully before handling brush holders and internal components.
• Fit brushes and holders in the correct orientation and ensure springs are seated properly.
• Do not operate the polisher if brush covers are missing, loose or damaged.
• If you are unsure about brush gear repairs, have the work carried out by a qualified technician or an approved service centre.